I designed a flower box for Mother's Day. The box can be used for different purposes. I put chocolates in this box.
Preview
Preview
Preview
Preview
Step 1: Cut out the parts
Preview
Preview
Setting 1
Process Method
Laser Cut
Process Material
Cherrywood Plywood
Power(%) or Cut Pressure(g)
100
Pass
1
Speed(mm/s)
17
Setting 2
Process Method
Vector Laser Engrave
Process Material
Cherrywood Plywood
Power(%) or Cut Pressure(g)
15
Pass
1
Speed(mm/s)
250
Lines per cm
100
Cut out the parts. The taps and slots are made 3mm. When you make the box bigger or smaller, you must resize the slots. And also when you make it from a different size wood.
Step 2: assemble the box
Preview
Preview
Preview
Preview
Use sandpaper to remove the scoring marks. Clean up with isopropohol alcohol
Click the bottom of the box into the front of the box (where it says Mother's Day). The slots are made at 3mm, if necessary use a hammer to click the side into place. If necessary, use wood glue to glue the edges together.
Cut out the parts. The taps and slots are made 3mm. When you make the box bigger or smaller, you must resize the slots. And also when you make it from a different size wood.