Drew's Den
Report

Fan Switch

Instruction
Fan.xcs
Fan
.xcs
Application scenario
Laser (10min)
Machine & module
xTool S1
40W
Material used
Black Opaque Glossy Acrylic Sheet
4
344
Information
      Do you ever forget which cable is for the light or fan? Instead of pulling them randomly, try out this small maker that I designed for your fan. 

33/312
    
Instruction
1
Step1: Design

I created the icons in XCS using simple graphics. Next, I made the component that connects to the fan. I used a small square and two holes for this purpose. Please keep in mind that although I used acrylic, you can use any material of your choice.

2
Step2: Material

For this project, I used acrylic. However, you can use any material that you prefer. Since it was my first time working with acrylic, some of the engravings were not very clear. Therefore, I suggest that you do a test square before starting your project.

3
Step3: Laser time

Please remember that this is black acrylic and an S1 40-watt laser, so make sure to adjust your parameters for both your machine and the material. Also, always wear laser-safe glasses when laser engraving.

4
Step4: You're Done
Preview

Now that you're done, you will never forget which cord is for your fan and which is for your light. Good job!

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1