HomeTemplatesOthers
PILED
Report
[Laser cut and engrave] Rust Removal
Project made with xTool F1 machine for Laser cut and engrave.
Project made with xTool F1 machine for Laser cut and engrave.
[Laser cut and engrave] Rust Removal
[Laser cut and engrave] Rust Removal
[Laser cut and engrave] Rust Removal
[Laser cut and engrave] Rust Removal

Rust Removal

Instruction
rust.xcs
rust
.xcs
Application scenario
Laser (10min)
Machine & module
xTool F1
2W
Compatibles · 5
Material used
Stainless Steel
96
1433

Information

      I used the 2W IR laser to remove rust from an old chisel

Instruction

1

Step1: Clean

Rust Removal instruction: step 1 - Clean
Preview

First, remove any excess rust. I used a scourer under the sink.

Then, completely dry with a paper towel.

Before above, after below. 

2

Step2: Preparation

Rust Removal instruction: step 2 - Preparation
Preview

Measure the length and width of the tool then change the square size in xTool creative space file.

Check the size is correct by framing. 

 

 

3

Step3: Engrave

Rust Removal instruction: step 3 - Engrave
Preview

90% of the surface-level rust has been removed from just one pass. More scouring of the most rusted spots would have ensured a more even finish. 

Before above, after below. 

Comments

Remixes

xTool Supplies Used in This Template

xTool F1
xTool F1

License

CC BY-NC-SA