HomeTemplatesTools & Special MaterialsJigs
gooptroop.ian
Report
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Slide Extension Bottle Opener Jig

SlideBottleOpener.xcs
SlideBottleOpener
.xcs
Application scenario
Laser (30min)
Machine & module
xTool F1
10W
Compatibles · 9
Material used
3mm Basswood Plywood
274
2589
Information
      This Jig will take 20 bottle openers. You will need the Slide Extension
1. Start with two 3mm plywood boards 400x115mm. 
2. Note the position of the 2 blocks on the slide extension. Do your normal side extension setup.
3. Run the files I did the score for the engrave alignment first. Then I ran the cut job.
4. Glue the two boards
Comments
Remixes
xTool Supplies Used in This Template
xTool F1
xTool F1
3mm Basswood Plywood
3mm Basswood Plywood