With all my builds I lay out all of the pieces in an order to help assembly.

Depending on how tight your slot cuts are, you might not need glue for this part.

I put a few drops here and there.

The upper front piece might need a little glue.

Line up the slots with the head piece tabs and press together.

I have a small rubber mallet that helped to get the two sections together.

Once you have done that put the lower teeth in the base and fix in place.

There are 3 pieces that have a square cut out. Two of these have the long rectangular slits for the arms.

the two with the arm slits go on the sides and the one without the slit goes on the back.

When the goggle holder goes on, you will put the holder in the square holes.

Glue the feet and lower base section together.

Glue the glove pieces to the hands. Don't get glue in the sign handle slot.

glue the base to the bottom of the head assembly. there are 4 slots for the base to go into. Glue the arms into the side body slots.  They are reversible so if you put the sign hand on the other side its ok.

If you've followed the steps you should have a new Minion friend!

If you have any issues please leave a message in the comments and I'll do my best to help you.