Report
Ice Cream Cone Earrings or a Cool Keychain
InstructionIce Cream Cone Earrings Key Chain
.xcs
Application scenario
Laser (5min)
Machine & module
xTool S1
40WCompatibles · 9
Material used
3mm Basswood Plywood
45
780
Information
It's Summer Time and what better way to show your excitement than a pair of Ice Cream Cone Earrings, decorate to make your favorite cone! You can also use to make a keychain!
My favorite is actually Chocolate! So they are pre-finished! Chocolate with a waffle cone…. Mmmmm delicious 😋
Instruction
1
Step1: Download and Open
Preview
Open the file in Xcs.
Check the sizing is correct for you. I set Earring typically at 2" in height.
2
Step2: Load your Material
Preview
Load your favorite material into the bed of the machine
3
Step3: Run the Job
Preview
The first cut and engrave are straight forward.
Just run the file as loaded.
4
Step4: Flip Earrings
Preview
To engrave the other side of the earrings, flip them to the location of the opposing earring.
The will be “upside down”
Turn off the Red “Cut” layer.
Run the job for engrave only.
5
Step5: Time to Decorate
Preview
Look at that both sides are engraved!
Now we can clean them up and decorate them to turn them into your Favorite Ice Cream Cones!
Will you have a matching set?
6
Step6: All Done!
Preview
Now that we are all decorated, let’s add the jump rings x2 per earring and the earring hooks!
I always use Silver Plated. As I have allergies.
Comments
Remixes
xTool Supplies Used in This Template