HomeTemplatesToys & Games & ModelsBoard Games
Drew's Den
Report
[Laser cut and engrave] Decision dice
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
[Laser cut and engrave] Decision dice
[Laser cut and engrave] Decision dice
[Laser cut and engrave] Decision dice
[Laser cut and engrave] Decision dice

Decision dice

Instruction
Decision Dice.xcs
Decision Dice
.xcs
Application scenario
Laser (10min)
Machine & module
xTool S1
40W
Material used
dice
44
430

Information

      Okay, should I buy a new laser? Making this decision was so difficult that I had to make a dice to help me decide.

64/312

Instruction

1

Step1: Design 1

Decision dice instruction: step 1 - Design 1
Preview
Decision dice instruction: step 1 - Design 1
Preview

First, I opened up my dice template and put all of the options inside the dice squares. Then, I made sure to set the material to basswood as it is similar to basswood.

2

Step2: Material

Decision dice instruction: step 2 - Material
Preview

For this, I used a dice that I found at a craft store, as it is rather difficult to make a die shape out of just basswood.

3

Step3: Laser time

Decision dice instruction: step 3 - Laser time
Preview
Decision dice instruction: step 3 - Laser time
Preview

Now it's time to laser your dice. Make sure to set each one individually as you will need to rotate it every couple of times. Also, these are the settings for an S1 40-watt laser, and don't forget to wear your laser safety glasses.

4

Step4: You're Done

Decision dice instruction: step 4 - You're Done
Preview

Now that you're done with your dice, you won't need to worry about making a decision again. Leave it up to your dice.

Comments

Remixes

xTool Supplies Used in This Template

xTool S1
xTool S1

License

CC BY-NC-SA