Wooden Protractor
Cora
·
139
944
Design Files (1)
  • Protractor.xcs
    M1
    • Description
    Did I need a protractor? No. Was this a fun project? Yes! 

I haven't used a protractor in over 15 years, but I also didn't want to create just a ruler. I thought it would be fun to make something that I haven't seen in a while. I might end up making a set with a ruler and right angle ruler too, just for fun! 

All I used was some 1.5MM scrap basswood and clear satin polycrylic. See below for how I did this project. If I had to do it over, I would make my power settings for the engraving a little higher so they are a bit deeper. I would also redo the tracing on the numbers, as they came out a bit distorted.
    Production Info
    Application scenario
    Laser
    Software
    xTool Creative Space
    Machine & processing module
    xTool M1
    10W
    Material used
    3mm Basswood Plywood
    1.5 MM basswood found on Amazon. Any wood will work though. Minwax polycrylic clear satin spray. 220 grit sanding block or paper.
    Total time
    30 min
    Also compatible with other machines. Visit the Material EasySet Library  for more.
    License
    CC0
    (aka CC Zero) is a public dedication tool, which allows creators to give up their copyright and put their works into the worldwide public domain.
    Do you like this project?