HomeTemplatesOffice & StationeryAwards & Recognition
jpn.ngo
Report
[Laser cut and engrave] Challenge Coin
Project made with xTool F1 Ultra machine for Laser cut and engrave.
Project made with xTool F1 Ultra machine for Laser cut and engrave.
[Laser cut and engrave] Challenge Coin
[Laser cut and engrave] Challenge Coin
[Laser cut and engrave] Challenge Coin
[Laser cut and engrave] Challenge Coin

Challenge Coin

Instruction
_1_875208.png
_1_875208
.png
Application scenario
Laser processing (114min)
Machine & module
xTool F1 Ultra
20W
Accessories
Desktop Air Purifier for xTool F1
Material used
0.3mm Brass
12
401

Information

      This is the back side of a Challenge Coin done as a test. It was my first attempt at doing a coin like this. Settings were adjusted for time and can be readjusted for deeper engraving
AImake Info
atomm-ai-image
Embossment
[Prompt]

Instruction

1

Step1

Set the coin in the workspace

Adjust Focus

Input material and settings into XCS

Use the AI to create a depth map of your desired image

Put generated image over coin

Process and Run Laser

Run Cleaning Pass

Clean and Polish Coin if needed

Comments

Remixes

xTool Supplies Used in This Template

Desktop Air Purifier for xTool F1
Desktop Air Purifier for xTool F1
xTool F1 Ultra
xTool F1 Ultra

License

CC0
This work contains AI-generated content.