HomeTemplatesDecorHome DecorShelves & Holders
arlisa1913
Report
Laser cut and engrave
Project made with xTool D1 machine for Laser cut and engrave.
Project made with xTool D1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Etching with the laser can be fun and simple

Instruction
Application scenario
Laser (25min)
Machine & module
xTool D1
20W
Material used
Tempera Paint
Glass
1183
Information
      I used a glass and some tempura paint. One coat is enough.  After the paint is dry, get your RA2 Pro and get busy!
Instruction
1
Step1: Prepare Your Glass

Start with a clean and dry glass.

Apply black tempura paint using a sponge brush.  Keep your strokes level and consistent.

2
Step2: Allow Paint to Dry

This will be a minimum of 30 minutes; sometimes I use a fan to expedite the process. 

3
Step3: Connect your RA2 Pro Rotary device

Connect your RA2 pro and be sure your settings are set to “rotary chuck”.

Set the diameter to 3.

4
Step4: Let's etch!

Place your glass on the rotary chuck.  Be sure your image is set in a mirror image.

I like to use 70% power and a speed of 30.

5
Step5: Wash your glass!

The dollar store magic erasers are priceless! Give them a try.  Clean your glass and allow to air-dry.

Comments
Remixes
xTool Supplies Used in This Template
xTool D1
xTool D1