Report
![[Laser cut and engrave] Santa's Magic Key](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/ae9f3c61-ca8d-48c4-abc7-27f85fda70f7?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Santa's Magic Key
InstructionSanta'sMagicKeyfile
.xcs
Application scenario
Laser processing (30min)
Machine & module
xTool P2
55WCompatibles · 1
Material used
3mm Basswood Plywood
3mm Glitter Translucent Acrylic
3mm Clear Transparent Glossy Acrylic
211
1070
Information
This is a wonderful way to incorporate Santa coming on Christmas Eve. Not everyone has a chimney for Santa so this is a cute idea for the kiddos to have.
Instruction
1
Step1
The clear acrylic is an offset of the actual key. The actual key is the glitter acrylic. I was concerned on the glue showing when you flip the key over but since it dries clear, there's no problem. Glue used is Starbond Multi-Purpose Medium glue from Amazon.
2
Step2
The engraving is on 3mm basswood. These settings are dialed in for our P2. You may have to adjust setting per your machine.
3
Step3
Everything cut out is also on 3mm basswood. Disclaimer: the scrollwork is very thin so you may also need to do an offset to make it thicker. You must be very careful to not snap them so it may be a good idea to cut out a few of each design. Everything is glued with Starbond Multi-Purpose Medium glue ordered from Amazon.
Comments