Atomm
Report

Hot Air Balloon Octave Wall Hanging

Instruction
Hot Air Balloon Wall Decoration.xcs
Hot Air Balloon Wall Decoration
.xcs
Application scenario
Laser processing、Inkjet printing (30min)
Machine & module
xTool M1 Ultra
10W
Material used
1/8"(3mm) Basswood Plywood
93
1911

Information

      Make a hot air balloon wall hanging with an octave!
    
Bill of Materials
xTool parts
atomm-bom-image
x1
atomm-bom-image
x1

* Currently only available in US store

Instruction

1

Step1: Preliminary

Hot Air Balloon Octave Wall Hanging instruction: step 1 - Preliminary
Preview
Hot Air Balloon Octave Wall Hanging instruction: step 1 - Preliminary
Preview
Hot Air Balloon Octave Wall Hanging instruction: step 1 - Preliminary
Preview

Switch on the machine, open the xTool Creative Space on the computer, drag in the required xcs file, dismantle the base plate, place the thick storage box with a height of 9cm inside, adjust the suitable height so that the inkjet head can just touch the surface of the board during the inkjet processing, this process requires your own continuous testing to verify that you find the right height.

2

Step2: Starting the Inkjet Procedure

Hot Air Balloon Octave Wall Hanging instruction: step 2 - Starting the Inkjet Procedure
Preview

The material is prepared, the parameters of the file are adjusted, the processing range is calibrated, and finally the parameters are confirmed and adjusted in preparation for the processing of the first step of the inkjet mode.

3

Step3: Laser Cut

Hot Air Balloon Octave Wall Hanging instruction: step 3 - Laser Cut
Preview

After processing, remember to cover the inkjet lid to prevent the ink from drying, according to the software prompts to load the 10w laser head module, you can inkjet completed on the board paste the textured paper and then laser cutting process, effectively alleviate the situation of yellowing of the board.

4

Step4: Assemble

Hot Air Balloon Octave Wall Hanging instruction: step 4 - Assemble
Preview
Hot Air Balloon Octave Wall Hanging instruction: step 4 - Assemble
Preview
Hot Air Balloon Octave Wall Hanging instruction: step 4 - Assemble
Preview
2 More images

After processing, proceed to the step of assembling and put in the drawstring octave.

5

Step5: Finish

Hot Air Balloon Octave Wall Hanging instruction: step 5 - Finish
Preview

Assembly is complete and the work is finished!

Comments

Remixes

xTool Supplies Used in This Template

xTool M1 Ultra
xTool M1 Ultra
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood