Projects
Designs Forum Contests
Tumblers for Christmas
43
791
0
Design Files
  • Tumblers for Christmas-Share.xcs
    • Contents
    Introduction
    Basic Information
    Settings
    Design Files
    I engraved a number of designs into Reduce branded tumblers from Sam’s Club. The attached xcs file is intended for use on the xTool F1 with the RA 2 chuck. I set the start point midway through the handle. I created four “quarter blocks” to help with centering the design on the “front” of the tumbler assuming the person would hold it with the handle in their right hand. I used the 10w diode for the first pass (Setting 1) and the 2w IR laser for the second pass (Setting 2). I separated the two using different layers and set the Processing path to “By layer.”
    Basic Information is loading...
    Settings
    Setting 1
    Process Method
    Vector Laser Engrave
    Process Material
    Stainless Steel Tumbler kit with Handle Seafoam
    Power(%) or Cut Pressure(g)
    80
    Speed(mm/s)
    400
    Lines per cm
    160
    Pass
    1
    Setting 2
    Process Method
    Vector Laser Engrave
    Process Material
    Stainless Steel Tumbler kit with Handle Seafoam
    Power(%) or Cut Pressure(g)
    40
    Speed(mm/s)
    400
    Lines per cm
    300
    Pass
    1
    Design Files
    Tumblers for Christmas-Share.xcs
    ChristmasCreations
    Do you like this template?
    Remixes (0)
    Add Remix
    There are no remixes yet.