4" picture on Slate Coaster
102
2095
3
Design Files
  • flask12.xcs
    • Contents
    Introduction
    Basic Information
    Settings
    Design Files
    With the slate coaster smoothed and prepared the results are quick nice.
    Preview
    Preview
    Preview
    4 More images
    Preview
    Preview
    Preview
    Preview
    Preview
    Preview
    Preview
    Basic Information is loading...
    Settings
    Setting 1
    Process Method
    Vector Laser Engrave
    Process Material
    Slate Coaster
    Power(%) or Cut Pressure(g)
    65
    Speed(mm/s)
    120
    Lines per cm
    220
    Pass
    1
    Other Parameters
    This prep work for these coasters is quite simple, with 150 grit sand paper and the use of an orbital sander it can sand down the high points of the coaster in just a few seconds of sanding. This new finish then gets a coat of matte clear sealer and the results are outstanding compared to original.
    Design Files
    flask12.xcs
    Slate, Coaster, XCS. Xtool,
    Do you like this inspiration?
    Remixes (0)
    Add Remix
    There are no remixes yet.