This board goes perfectly with my monthly planner board. Together they make life just that little bit easier and organised!
Preview
Preview
Step 1: Placement
Preview
Preview
Setting 1
Process Method
Laser Cut
Process Material
Transparent Acrylic
Acrylic
Power(%) or Cut Pressure(g)
100
Pass
1
Speed(mm/s)
20
Setting 2
Process Method
Laser Score
Process Material
Transparent Acrylic
Acrylic
Power(%) or Cut Pressure(g)
10
Pass
1
Speed(mm/s)
600
Setting 3
Process Method
Vector Laser Engrave
Process Material
Transparent Acrylic
Acrylic
Power(%) or Cut Pressure(g)
20
Pass
1
Speed(mm/s)
600
Lines per cm
200
Ensure that the board fits over the material you have placed in you laser and adjust the settings according to the material you are using.
Green engrave
orange score
blue cut
black optional cut
Step 2: Finishing off
Preview
Preview
If you plan on using magnets then glue magnets to the back of the board. To make it look more pleasing to the eye I added magnets to the front as well. This option is up to you.
If you would rather hang the board then make sure you have cut the two optional holes at the top of the board. Place string or ribbon through and hang.
Ensure that the board fits over the material you have placed in you laser and adjust the settings according to the material you are using.
Green engrave
orange score
blue cut
black optional cut
If you plan on using magnets then glue magnets to the back of the board. To make it look more pleasing to the eye I added magnets to the front as well. This option is up to you.
If you would rather hang the board then make sure you have cut the two optional holes at the top of the board. Place string or ribbon through and hang.