Instead of using a powder coated tumbler I wanted to try a plain Stainless Steel tumbler. I did burn the back side and warp the back side of this tumbler the first try! So be carful of your settings!!!
Basic Information is loading...
Step 1: Upload file into Creative Space
Setting 1
Process Method
Vector Laser Engrave
Process Material
Stainless Steel
Power(%) or Cut Pressure(g)
100
Speed(mm/s)
45
Lines per cm
300
Pass
2
Other Parameters
Bi Directional
1.Upload file into Creative Space
2. Make sure you edit to your own name at the bottom
3. Make sure your settings are correct and you have selected Pre Heat in the Settings for the IR settings in the settings tab under the BIG X in the upper left corner of your screen.
4. Set up your Tumbler in your F1
5. Set your Focus
6. Run your framing for you correct positioning
7. Put on your protective goggles
8.Select Process
9.Select Start
10. Push the Button on your F1 and watch the magic happen!!!
1.Upload file into Creative Space
2. Make sure you edit to your own name at the bottom
3. Make sure your settings are correct and you have selected Pre Heat in the Settings for the IR settings in the settings tab under the BIG X in the upper left corner of your screen.
4. Set up your Tumbler in your F1
5. Set your Focus
6. Run your framing for you correct positioning
7. Put on your protective goggles
8.Select Process
9.Select Start
10. Push the Button on your F1 and watch the magic happen!!!
GOOD LUCK AND HAPPY CRAFTING!!!