The original design was for a loved one, and since I'm giving it to my mother, I changed the decorative pattern and name.
*Pictures 1 and 2 are the modified design and pictures 3 and 4 are the original design.
Step 2: Cut
Setting 1
Process Method
Laser Cut
Power(%) or Cut Pressure(g)
90
Speed(mm/s)
2
Pass
1
Put in the wood, confirm the cutting position, cutting.
Step 3: Assemble
2 More images
Start with the base, then assemble according to the order shown in the picture. Be sure not to assemble the boards that are opposite each other first, as this will make assembly difficult.
Please note, due to the tight fit of this design, if you encounter a situation where it does not fit, use sandpaper to thin the joint.
Step 4: Waste Utilisation
Make the most of your scraps by turning cut-out patterns into earrings. Just punch a hole in them.
The original design was for a loved one, and since I'm giving it to my mother, I changed the decorative pattern and name.
*Pictures 1 and 2 are the modified design and pictures 3 and 4 are the original design.
Put in the wood, confirm the cutting position, cutting.
Start with the base, then assemble according to the order shown in the picture. Be sure not to assemble the boards that are opposite each other first, as this will make assembly difficult.
Please note, due to the tight fit of this design, if you encounter a situation where it does not fit, use sandpaper to thin the joint.
Make the most of your scraps by turning cut-out patterns into earrings. Just punch a hole in them.