DesignFind

I had some scraps laying around and decided to make an incense holder for fun. I am using the XTool D1 Pro 10W. 

I cut off the end of some walnut stock and now have a 3x3x1 inch block. (3 inch by 3 inch square thats 1 inch thick). 

Using the xTool Creative Space, I decided to find a simple pattern to engrave fairly deep into the block for aesthetic, in addition to adding a hole with a pilot drill that will hold the incense stick safely. 

This will work with any off cut that you decide to use, I just used Walnut since I had a generous amount to work with. If you are using a softer wood like pine or even poplar, use the power setting at 80% with the speed at 60.