A simple, but elegant wall decoration "Welcome" sign. 3 layers, easily cut from 12" squares.
Basic Information is loading...
Step 1: Load and adjust the design.
This sign can easily be largened, if desired. Simply load into your software (I use XCS) and resize the design. There are no tabs to worry about. Everything will be resized proportionally.
Step 2: Cut it!
Setting 1
Process Method
Laser Cut
Process Material
6mm Birch Plywood
Power(%) or Cut Pressure(g)
100
Speed(mm/s)
10
Pass
1
Other Parameters
I play it safe and also lower the focus by 3mm.
When ready, load your wood, set the distance, then mark your processing area. If you wish, you can frame it. I sometimes need to worry about the honeycomb hold-downs, as they get in the way and need to be moved. When ready - process you cuts.
Load - Adjust - Cut - Repeat for each layer.
Step 3: Glue together then Paint or Stain
Glue the three layers together, being sure they are aligned properly to show the different layers. When dry, you can stain or paint the wood to your preference.
This sign can easily be largened, if desired. Simply load into your software (I use XCS) and resize the design. There are no tabs to worry about. Everything will be resized proportionally.
When ready, load your wood, set the distance, then mark your processing area. If you wish, you can frame it. I sometimes need to worry about the honeycomb hold-downs, as they get in the way and need to be moved. When ready - process you cuts.
Load - Adjust - Cut - Repeat for each layer.
Glue the three layers together, being sure they are aligned properly to show the different layers. When dry, you can stain or paint the wood to your preference.