Nice weather means outdoors more often and what is outside is a garden here is a new stepping stone made for the garden...
Preview
Preview
Preview
3 More images
Preview
Preview
Preview
Preview
Preview
Preview
Step 1
Preview
Preview
Preview
Preview
Preview
Preview
Preview
Preview
Setting 1
Process Method
Vector Laser Engrave
Power(%) or Cut Pressure(g)
100
Pass
1
Speed(mm/s)
80
Other Parameters
Simple trick to center round objects, find center of circle place a piece of masking tape to mark a dot. on the processing page select the start point to center and magically your image /design will be center.
Lines per cm
100
Step 1) Starting with a fresh opening of XCS software a 12" circle is made for framing purposes, this happens to be the size of the stepping stone. A SVG of a design is brought into the work area from using the image button. It is then placed in the center of the circle and the engraving adjustments are made.
Step 2
Preview
Preview
Preview
2 More images
Preview
Preview
Preview
Preview
Preview
Step 2) Remove from laser machine and blow off the surface with a compressor to remove any dust that may have been created. seal it with a clear polyurethane. place it anywhere outside to enjoy the new stepping stone.
Step 1) Starting with a fresh opening of XCS software a 12" circle is made for framing purposes, this happens to be the size of the stepping stone. A SVG of a design is brought into the work area from using the image button. It is then placed in the center of the circle and the engraving adjustments are made.
Step 2) Remove from laser machine and blow off the surface with a compressor to remove any dust that may have been created. seal it with a clear polyurethane. place it anywhere outside to enjoy the new stepping stone.